Let’s talk about the 380V 2000W Quartz Halogen Heater
If you’re running flash drying machines, you know that waiting around for things to heat up is a productivity killer. That’s why we built these 610mm quartz halogen lamps. Here’s the secret: they use shortwave infrared. Instead of wasting time heating up the air around the part, these lamps shoot energy straight into the material. It’s direct. It’s fast. It just works. The power behind it We pushed these to 380V and 2000W because we wanted a high watt-density across that 610mm stretch. By using 380V, we can cram 2kW of power through the filament without the current getting out of control. The result? You hit your target temperatures in seconds. Just a heads-up though—if you’re wiring these into a high-speed line, make sure your controllers can take that initial cold-start spike. You don’t want to be chasing tripped breakers in the middle of a shift. Why quartz and halogen? We use a high-purity quartz envelope and fill it with a specific halogen gas mix. This stops the tungsten filament from evaporating and clouding up the glass. It keeps the tube crystal clear, which means the lamp lasts longer. Plus, since quartz doesn’t hold onto heat, the lamp hits full blast almost the instant you flip the switch. Putting them to work These are designed to slide right into industrial drying tunnels. Since 610mm is a standard size for wide-web drying, they usually drop right in. You get a concentrated beam of heat that actually sinks deep into your inks or coatings, rather than just scorching the surface. But look, 2000W in a tube this size creates a lot of intense, localized heat.Don’t skim on your reflectors or cooling fans. If your housing doesn’t have a way to breathe, you’re going to melt your wiring or warp the frame of your machine. I always recommend using high-temp silicone leads. It’s a small detail, but it keeps your insulation from burning out when you’re running 24/7.